Bush Hog 4815
Features
CONSTRUCTION FEATURES
- Heavy structure on center section and wings.
- Wing skids are 3/8” thick with an outside angle of 45 degrees to stop “ground dig-in” during turns.
- All axle spindles are half shafts for quick and less costly maintenance.
- Center section blades align closely with outside center tires to closely cut out the bottom of ditches.
- Grease fittings and spring steel bushings are at axle pivot points for longer life.
- Each cutting gearbox has a 3 inch output shaft with more and deeper splines than competitor models for maximum torque load capabilities.
- All drivelines are EZ lube with grease points aligned and the cross bearing fitting is in the end cap.
SAFETY FEATURES
- Highway Safety Lights Standard
Specifications
| MODELS | 4815 |
| CUTTING WIDTH | 15' |
| CUTTING HEIGHT | 2″ -14″ |
| CUTTING CAPACITY | 4 1/2" |
| TRANSPORT WIDTH* | 8' 2" |
| TRANSPORT HEIGHT** | 7' 3" |
| TRANSPORT LENGTH*** | 15' 3" |
| APPROXIMATE WEIGHT (LB) | 6,200 |
| APPROXIMATE TONGUE WEIGHT (LB.) | 2,700 |
| MINIMUM TRACTOR PTO HP | 70 |
| HITCH | "PERMA-LEVEL" OR BALL HITCH |
| CENTER DECK | 11GA OVER 7GA |
| WING DECKS | 7GA |
| WING CUTTING ANGLES | 22° DOWN AND 45° UP |
| WING LEVEL ADJUSTMENT | TURNBUCKLES |
| SIDEBANDS | 1/4″ X 13 1/2″ |
| TRANSFER GEARBOX (HP) | 250 |
| CUTTING GEARBOX (HP) | 225 |
| INPUT DRIVELINE | CATEGORY 6 |
| CUTTING DRIVELINES | CATEGORY 5 |
| BLADE HOLDER | 7GA ROUND |
| BLADES | 1/2″ X 4″ |
| BLADE TIP SPEED (FPM) | 16,268 |
| AXLE SUSPENSION | SPRINGS @ EACH AXLE |
| CENTER & WING HYDRAULICS | 3 HOSES STANDARD |
| SAFETY TOW CHAIN | STANDARD |
| DISTRIBUTION BAFFLES | OPTIONAL |
| PTO DRIVELINE SUPPORT | OPTIONAL |
